生石灰孔结构对高温脱硫性能的影响

喷钙脱硫工艺的炉内脱硫率 ,不仅受工艺参数的影响 ,还与石灰石分解生成的新生CaO或直接喷入的CaO的表面结构有关。本研究用同一石灰石经不同方法 (煅烧、过烧、煅烧 -水合 -脱水等 )制备了四种具有不同比表面积和孔结构的生石灰。高温脱硫研究表明 :这四种不同孔结构的生石灰 ,具有不同的脱硫率。通过对高温脱硫前后吸着剂宏观结构变化的对比 ,发现半径小于 30 的孔易被反应产物堵塞 ,因而脱硫能力有限 ,而半径大于 5 0 的孔对脱硫更有效。本研究将为提高炉内喷钙的脱硫率、研制和开发高效脱硫剂提供新的途径。     

河北省钢铁工业主要大气污染物减排潜力分析

通过对河北省钢铁工业存在问题的分析,得出我省钢铁行业主要大气污染物为二氧化硫和粉尘.结合我省钢铁企业的实际情况,从工程技术、政策管理等方面提出相应治理措施,并对"十一五"期间我省钢铁行业二氧化硫和粉尘减排效益进行预测.预测结果显示:采用所建议的减排措施后,我省钢铁工业二氧化硫减排量对全省"十一五"减排计划的贡献率为81.4%;粉尘可减排60%.     

储罐硫腐蚀产物标志性气体的监测

含硫油品储罐内的腐蚀产物与油品中的活性硫反应生成硫化物,而此类硫腐蚀产物氧化自燃是导致储油罐发生火灾、爆炸事故的重要原因.通过试验考察了氧气体积比对硫腐蚀产物氧化自燃过程的影响,探索了铁锈模拟物在氧化过程中SO2气体的释放规律.结果表明:氧气浓度越高,硫腐蚀产物的自燃危险性越大;随着O2浓度增加,氧化反应中SO2的浓度越大,SO2气体析出速度越快,当氧化反应的温度为40℃时,SO2气体浓度达到最大.     

活化改性半焦用于烟气脱硫催化剂制备工艺优化

为研究不同制备工艺条件下的烟气脱硫催化剂吸附去除烟气中硫化物的性能,采用硝酸活化的半焦脱硫剂,通过穿透时间和硫容评价所制备催化剂的脱硫性能.采用固定床反应器考察了催化剂表面基团酸碱性、催化剂成型的制备顺序、黏结剂和催化剂尺寸及负载金属氧化物等制备工艺条件对催化剂脱硫性能的影响.结果表明:原料半焦表面呈碱性,半焦经硝酸氧化改性后,表面呈酸性,高温煅烧可以使半焦表面酸性官能团分解成碱性官能团,催化剂表面净碱量越大,脱硫性能越好;采取先将半焦成型再进行高温煅烧、水气活化的工艺,脱硫活性更高;最适合的黏结剂为煤焦油;最佳的催化剂粒径为3mm;烟气中通入O2能显著提高半焦吸附催化剂的脱硫性能,O2体积分数以5％为宜,烟气中适量H2O是脱硫必不可少的条件,水汽体积分数以8％最佳;在催化剂制备过程中添加质量分数为1％的V2O5,可以明显改善催化剂的脱硫性能.     

不同磁黄铁矿自养反硝化脱氮除磷作用

氮磷排放标准日趋严格,开发高效廉价脱氮除磷材料已成为研究热点.采用黄铁矿与赤铁矿在管式炉中氮气气氛下600 ℃煅烧,得到硫化赤铁矿形成的磁黄铁矿、黄铁矿热分解形成的磁黄铁矿,构建磁黄铁矿-方解石体系处理含氮磷模拟废水,对比不同方式制备的磁黄铁矿、天然磁黄铁矿、黄铁矿、硫磺脱氮除磷性能,考察不同磁黄铁矿晶体结构和结晶度差异及其对脱氮除磷影响,探究不同体系中矿物结构和微生物群落变化.结果表明：黄铁矿热分解产物以六方磁黄铁矿为主;硫化赤铁矿产物以低结晶度的单斜磁黄铁矿为主,因而表现出优异的脱氮除磷活性,氮磷去除率分别为99.8%和96.8%.铁硫化物与微生物反应产物的XRD、SEM和FE-TEM分析结果表明,微生物能有效利用磁黄铁矿进行脱氮,磷酸盐主要以FePO₄形式被去除.群落分析结果表明铁硫化物脱氮除磷体系中的主要功能菌属为Thiobacillus和 Sulfurimonas,结晶度低的单斜磁黄铁矿更有利于Thiobacillus定向富集.     

包埋硫铁生物填料的制备及自养反硝化性能

采用包埋固定化技术制备了包埋硫铁生物填料(ESI Filler),基于升流式自养反硝化反应器开展动态实验研究,通过改变水力停留时间(HRT)、pH值、溶解氧(DO)等运行条件,探究ESI Filler反应器的脱氮效果及微生物群落结构组成。结果表明,当进水硝酸盐氮(NO₃^--N)浓度为30mg/L,HRT为10h时,NO₃^--N去除率不断上升至99.80%。当HRT缩短为2.5h时,NO₃^--N去除率降至61.35%。ESI Filler反应器对pH值和DO的改变具有较高的稳定性,NO₃^--N平去除率可维持在82.5%以上。但对低温的耐受性较差,当温度从35℃降低至15℃时,NO₃^--N平均去除率由90.12%降低至68.80%。运行164d后,球体未出现破裂散落的现象,表现出较长的使用寿命。通过扫描电镜发现,填料表面疏松多孔,附着大量杆状细菌,已成为微生物的良好载体。高通量测序结果表明,包埋颗粒中优势菌属为典型的自养反硝化功能菌Thiobacillus,丰度为80.79%。     

外源硫诱导下的Desulfovibrio desulfuricans sub sp.EPS特性及对Zn(Ⅱ)的吸附

研究了3种外源硫(Na₂SO₄、Na₂SO₃和Na₂S₂O₃·5H₂O)对Desulfovibrio desulfuricans sub sp.(D.desulfuricans sp.)的胞外聚合物(EPS)的胁迫/诱导作用。结果表明,在还原性硫源0.50g/L Na₂SO₃的条件下,EPS产量最高,为2104.39mg/g VSS,蛋白质含量为1888.52mg/g VSS,较胁迫/诱导前均提高了300%以上;其对Zn(Ⅱ)的吸附性能最好,为954.4mg/g EPS,提高了98.17%。三维荧光(3D-EEM)结果表明,胁迫/诱导后EPS中类酪氨酸均大量增加;傅里叶红外光谱(FTIR)结果表明,胁迫后-OH、C=O、C-O-C等官能团均大量增加,在Zn(Ⅱ)的吸附中发挥了重要作用;X光电子能谱(XPS)结果表明,在还原性硫源(Na₂SO₃和Na₂S₂O₃·5H₂O)胁迫/诱导后,EPS中C-O/C-N、C=N和某种含氧基团(X)大量增加,可能是吸附Zn(Ⅱ)的主要基团。     

氮气搅拌下高硫铝土矿电解脱硫研究

采用氮气搅拌的方法,强化高硫铝土矿电解脱硫过程,考察了电解液配比、电流密度、气流速度等因素对脱硫率的影响。研究表明：脱硫率随电解液中NaCl含量增加而增加;电解脱硫率随着NaOH浓度和电流密度先升高后下降;增加气体流速能够显著提高电解脱硫率。基于电解脱硫特点,提出了铝土矿电解脱硫工艺与现有氧化铝生产的衔接方式。     

A conceptual framework: Redefining forest soil's critical acid loads under a changing climate

Federal agencies of several nations have or are currently developing guidelines for critical forest soil acid loads. These guidelines are used to establish regulations designed to maintain atmospheric acid inputs below levels shown to damage forests and streams. Traditionally, when the critical soil acid load exceeds the amount of acid that the ecosystem can absorb, it is believed to potentially impair forest health. The excess over the critical soil acid load is termed the exceedance, and the larger the exceedance, the greater the risk of ecosystem damage. This definition of critical soil acid load applies to exposure of the soil to a single, long-term pollutant (i.e., acidic deposition). However, ecosystems can be simultaneously under multiple ecosystem stresses and a single critical soil acid load level may not accurately reflect ecosystem health risk when subjected to multiple, episodic environmental stress. For example, the Appalachian Mountains of western North Carolina receive some of the highest rates of acidic deposition in the eastern United States, but these levels are considered to be below the critical acid load (CAL) that would cause forest damage. However, the area experienced a moderate three-year drought from 1999 to 2002, and in 2001 red spruce (Picea rubens Sarg.) trees in the area began to die in large numbers. The initial survey indicated that the affected trees were killed by the southern pine beetle (Dendroctonus frontalis Zimm.). This insect is not normally successful at colonizing these tree species because the trees produce large amounts of oleoresin that exclude the boring beetles. Subsequent investigations revealed that long-term acid deposition may have altered red spruce forest structure and function. There is some evidence that elevated acid deposition (particularly nitrogen) reduced tree water uptake potential, oleoresin production, and caused the trees to become more susceptible to insect colonization during the drought period. While the ecosystem was not in exceedance of the CAL, long-term nitrogen deposition pre-disposed the forest to other ecological stress. In combination, insects, drought, and nitrogen ultimately combined to cause the observed forest mortality. If any one of these factors were not present, the trees would likely not have died. This paper presents a conceptual framework of the ecosystem consequences of these interactions as well as limited plot level data to support this concept. Future assessments of the use of CAL studies need to account for multiple stress impacts to better understand ecosystem response.